Disassembling & Reassembling Precihole Air Rifle

[Mona singh]

Bro plz upload dissembling of nx 100 nitro piston air rifle

[Sasho]

Please help me how to remove the barrel of precihole px100 achilles

[Rudransh]

Bro plz upload dissembling of nx 100 nitro piston air rifle

Hello Mona
Remove scope if u have mount and see there are two small grub alien screws in that 11m m dovetail which can seen from top side see where barrel is pushed inside block(hope it doesn't sound bad)..remove those screws and simply u can pull out the barrel ..But first why u need to remove barrel?
Note: Before removing barrel u need to degas the gun remove the manomtr (just screw out) then loose the 8 clamp (which hold barrel and air tank) it also has three small screw which needs to loosened then proceed with barrel removing.

Hope this helped

Regards
Veerbhadra

[ubaid]

Thanks GNV for such a detailed post. It helped me a lot in understanding the trigger system.
I am using NX200.

Actually I have messed with my upper sear. As I was compressing I left the upper sear down after replacing the piston and compressed, which I could not and all the pressure came on the sear. This made the sear bend now the gun is not at all engaging (loading). And I am not able to remove the piston too. I can see the upper sear teeth blocking the piston even after lifting the sear completely up.

Your post gave an idea and the mistake I have done.
Please advise.
1. How to remove the piston.
2. Do I have to hold the upper sear up while Compressing and lower it only after fitting the piston lock?

Awaiting your response
Regards
Ubaid