This is something that I made fabricating and assembling for indoor plinking. The biggest challenge was getting the sleeves for securing the spinner in place. I could not find it in India and after months of research, got them again from China. Finally when I got them, I found that ellen key for that size was not available anywhere in India. Again got it from China. Got the rods cut to size. Made the base from plywood waste saved when I did some furniture and got a mini bar bender lathed. Learning. Crude job as I am not an engineer or even a good craftsman but nevertheless did something that made me happy. I intend to do more of these for those who like it. But please.... don't expect anything fast. I am a good procrastinator there but determined. I tested this indoor & outdoor and so far so good. Only concern is when shooting indoor, ricocheting would be a concern, but I figured that pasting a circular piece of thermocole stuck to it should take care of it. Not tried, just a thought.
I look forward to having your comments, brickbats and bouquets, I am not a keyboard warrior so do unleash.
Only remember, I am not a genius at these things or anything else either. Anyone wishing to contact me, please feel free.
Rajendra Rajani
