gd air rifle

ranjithrobert · Post by **ranjithrobert** » Wed Jun 03, 2015 4:42 pm

hello to all members

recently i have bought gd600 am facing a problem with boring port where we use to load pellets the surronding is getting damaged after every short. kindly suggest your valuble suggestion for resolve it thanks in advance.

and also i had heard that gd is also making model 800 with German wood finish kindly give me any information upon the same.

thanks once-again

ibalajis · Post by **ibalajis** » Wed Jun 03, 2015 7:19 pm

Hi Ranjith, we have so many expert airgunners here who would gladly help you out of your problem. A few pics would be of great assistance.

Basu · Post by **Basu** » Fri Jun 05, 2015 10:32 am

Is it the pellet skirt getting deformed after you close the barrel ??

Basu

brihacharan · Post by **brihacharan** » Fri Jun 05, 2015 10:37 am

ibalajis wrote:Hi Ranjith, we have so many expert airgunners here who would gladly help you out of your problem. A few pics would be of great assistance.

Come on, lets see it

Briha

ranjithrobert · Post by **ranjithrobert** » Mon Jun 08, 2015 7:59 pm

thanks a lot for all the members will update the pic shortly

ranjithrobert · Post by **ranjithrobert** » Wed Jun 10, 2015 2:17 pm

dear members

kindly find the pic attached the boring port is get damages as well the pellet skirt getting deformed after closeing the barrel kindly suggest me your valuable inputs to resolve my solution thanks for all members for extending their time for sorting out the issue.

thanks

brihacharan · Post by **brihacharan** » Wed Jun 10, 2015 5:42 pm

ranjithrobert wrote:dear members
kindly find the pic attached the boring port is get damages as well the pellet skirt getting deformed after closeing the barrel kindly suggest me your valuable inputs to resolve my solution thanks for all members for extending their time for sorting out the issue.
thanks

> From the pictures it appears that the interlocking surfaces (transfer port & breech) are not machined properly which affects proper engagement....
> Also the breech 'OD' could be less than the pellet's skirt OD....
> These need to be attended to with some skill as otherwise there will be tremendous loss of out put (air pressure) when the AR is fired...
> If you are not a skilled DIY person, I would suggest you take the gun to the dealer from where you bought it & get it rectified by a gunsmith....
Good Luck!
Briha

Basu · Post by **Basu** » Wed Jun 10, 2015 5:44 pm

Dear,
The pics.are out of focus.....
Pl.post a a perfect pic.to get to the issue.

Basu

ranjithrobert · Post by **ranjithrobert** » Fri Jun 12, 2015 3:57 pm

thanks to all members for helping, Mr.briha i am taking an local gunsmith help to rectify it soon will post the results

ranjithrobert · Post by **ranjithrobert** » Sat Jun 13, 2015 3:38 pm

" i had heard that gd is also making model 800 with German wood finish kindly give me any information upon the same. " dear members kindly send in any information upon the same

Indians For Guns

Indians For Guns

gd air rifle

gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle

Re: gd air rifle