IHP 35 - irritating rear sight problem solved

All posts related to air-guns (air-rifles, airsoft, air-pistols, air-guns etc.).
Post Reply
bennedose
Shooting true
Shooting true
Posts: 930
Joined: Sun Mar 03, 2013 7:30 pm

IHP 35 - irritating rear sight problem solved

Post by bennedose » Fri Mar 20, 2015 9:40 am

Among the most irritating and intractable problems I faced with my IHP 35 from day one was the fact that it was shooting so low and so far to the left that full adjustment of the rear sight for highest elevation and windage was still no use. I had to settle for experimenting with 6-7 different pellet brands and find one that happened to be just OK - that brand just happened to shoot low and to the right compensating partially for my IHP 35's faulty sight.

I finally solved the problem as follows.

I raised the height of the entire rear sight by putting washers under the holding screws. This was not enough because the stupid damn spring loaded pin that the IHP has as part of the elevation mechanism kept slipping out of position. So I removed the offending pin and replaced it with a flat ended screw. That screw simply sits there - like the old pin. It is not screwed in position. The presence of the pin (or the screw I have used) is essential for the sight to be raised further because the elevation dial presses down on the screw (formerly pin) and pulls up the rear sight like a man pulling up his socks by pushing down his foot down into the sock.
ihp35-rearsight.jpg
As regards the windgae adjustment, I simply loosened the screw holding the foresight and tilted it to a slight angle to correct the windage. I now see a slightly tilted front sight pillar when I shoot - but I don't care as long as it shoots straight.

Finally I can try a wider range of pellets with my IHP 35
You do not have the required permissions to view the files attached to this post.

For Advertising mail webmaster
User avatar
brihacharan
Old Timer
Old Timer
Posts: 3112
Joined: Fri Jan 22, 2010 3:33 pm
Location: mumbai

Re: IHP 35 - irritating rear sight problem solved

Post by brihacharan » Fri Mar 20, 2015 10:30 am

Good work bennedose :clap:
On my part I just got fed up tinkering with it & had it replaced with an original Diana 35 rear sight :lol:
Briha

User avatar
Basu
Veteran
Veteran
Posts: 1483
Joined: Wed Apr 08, 2009 7:14 pm
Location: Salt Lake Kolkata

Re: IHP 35 - irritating rear sight problem solved

Post by Basu » Fri Mar 20, 2015 7:08 pm

Dear benne,
Backsight of such an high altitude , may not allow you to place your cheek on the butt.
Is that okay for you ??

Basu
Not all those wander , are lost...............

bennedose
Shooting true
Shooting true
Posts: 930
Joined: Sun Mar 03, 2013 7:30 pm

Re: IHP 35 - irritating rear sight problem solved

Post by bennedose » Sat Mar 21, 2015 10:06 am

Basu wrote:Dear benne,
Backsight of such an high altitude , may not allow you to place your cheek on the butt.
Is that okay for you ??

Basu
Basu the words cheek and butt together make me recall a thousand jokes with those words - but I won't get into that ROTFL

More seriously - the total amount that the rear sight has been raised is about 1 cm so it does not make too much of a difference to the cheekrest.

User avatar
Basu
Veteran
Veteran
Posts: 1483
Joined: Wed Apr 08, 2009 7:14 pm
Location: Salt Lake Kolkata

Re: IHP 35 - irritating rear sight problem solved

Post by Basu » Sat Mar 21, 2015 4:00 pm

Hah Hah Ha.......benne....
However, I am able to refresh your old sweet memories.....

Basu
Not all those wander , are lost...............

vivek16sep1969
Almost at nirvana
Almost at nirvana
Posts: 126
Joined: Thu Feb 07, 2013 4:11 pm
Location: Lucknow

Re: IHP 35 - irritating rear sight problem solved

Post by vivek16sep1969 » Sat Mar 21, 2015 5:04 pm

Good job sir.....
"Fast is fine but accuracy is everything......"
-Wyatt Earp

User avatar
Ultimate Sniper
Almost at nirvana
Almost at nirvana
Posts: 100
Joined: Sat Mar 10, 2012 2:01 am
Location: Bangalore

Re: IHP 35 - irritating rear sight problem solved

Post by Ultimate Sniper » Sat Mar 21, 2015 7:37 pm

Wonderful jugaad bennedose...
It looks a bit weird, staying so tall, but its fair so long as it works and does the job for us...

-Arvind S.

Post Reply