....old trigger out with the disposables....

...new trigger installed....

recommended....even otherwise it is just a slip fit...
1. clean trigger off old lubes once the old blade is removed....you need not disassemble the whole trigger
2. check for clear movement inside trigger housing once new blade is in...lube the sides of the new blade with moly sparingly and the lever contact points with the intermediate lever
3. smoothen the edges of the first and second stage adjustment screw tips and apply a little moly
4. moly lube the fat pin (rear, where the anti bear trap comes in) and also the trigger pin (front)...
5. adjust the two stages to your liking and just shoot...
regards
p k jeetesh