ARMINIUS .32 revolver
- eljefe
- Old Timer
- Posts: 2876
- Joined: Sun Jun 04, 2006 3:37 am
RP-
Arminius were a very popular 'Brand India' in Singapore in the 80's
250 Sing $ for a package deal of a 7 shot revolver, 25 rounds of no name ammo and airport transfer.
One I tried out,shot all over a 12 inch x 12 inch target at 25 yds, bench rested.No way I could get better groups than that. Please do try out a cylinder , at your cost if need be, before you plonk your money for it.
Badshah, I am vaguely beginning to understand a bit about your hypothesis -you say that the cartridge in a revolver slips backwards when its pointed 90 degrees up in the air? Please elaborate again.
May have been a one off occurence due to improper tolerances, but is this a repeatable exercise? applies to any revolver? I dont think so...
Best
Axx
Arminius were a very popular 'Brand India' in Singapore in the 80's
250 Sing $ for a package deal of a 7 shot revolver, 25 rounds of no name ammo and airport transfer.
One I tried out,shot all over a 12 inch x 12 inch target at 25 yds, bench rested.No way I could get better groups than that. Please do try out a cylinder , at your cost if need be, before you plonk your money for it.
Badshah, I am vaguely beginning to understand a bit about your hypothesis -you say that the cartridge in a revolver slips backwards when its pointed 90 degrees up in the air? Please elaborate again.
May have been a one off occurence due to improper tolerances, but is this a repeatable exercise? applies to any revolver? I dont think so...
Best
Axx
''It dont mean a thing, if it aint got that zing!''
"...Oh but if I went 'round sayin' I was Emperor, just because some moistened bint lobbed a scimitar at me, they'd put me away..."
"...Oh but if I went 'round sayin' I was Emperor, just because some moistened bint lobbed a scimitar at me, they'd put me away..."
-
- Shooting true
- Posts: 783
- Joined: Wed Dec 06, 2006 3:14 pm
- Location: Qatar
Re: ARMINIUS .32 revolver
Dear AXX,
i meant When we load Ammo in revolver,they are slightly loose in the cylinder.so when we point the revolver towards sky they come back little,as there is a gap between cylinder and the frame(i am attacthing a picture to give u an idea).
i meant When we load Ammo in revolver,they are slightly loose in the cylinder.so when we point the revolver towards sky they come back little,as there is a gap between cylinder and the frame(i am attacthing a picture to give u an idea).
Re: ARMINIUS .32 revolver
The story about revolver not firing when pointing upwards,concerns the Erma revolvers . The going price for these is around 1 Lakh (95,000-1,25,000/-)
penpusher
penpusher
-
- Almost at nirvana
- Posts: 232
- Joined: Tue Apr 03, 2007 12:25 am
- Location: Kolkata
- Contact:
Re: ARMINIUS .32 revolver
Hi, these ARMINIUS revolvers are not looking cheap. They are made by Weihrauch, Germany. They fire .22LR, .22WMR and our very own .32S&W Long bullets.
Lawman
Lawman
-
- Old Timer
- Posts: 2653
- Joined: Sat Jun 03, 2006 12:43 am
- Location: UK
Re: ARMINIUS .32 revolver
"They fire .22LR, .22WMR and our very own .32S&W Long bullets."
But not in the same revolver.
But not in the same revolver.
-
- Almost at nirvana
- Posts: 232
- Joined: Tue Apr 03, 2007 12:25 am
- Location: Kolkata
- Contact:
- Rudra
- Almost at nirvana
- Posts: 116
- Joined: Sat Aug 11, 2007 2:50 am
- Location: Patna (Bihar)
Re: ARMINIUS .32 revolver
In my opinion the revolvers are not very durable and are also cheap.
A guy here is ready to sell it at one lack INR but even then he is not getting the desired response.
i have fired about 14 rounds from it and the weapon wasn't able to leave a mark.
Its much better to go for an IOF .32 than an Arminius.
Regards
Rudra
A guy here is ready to sell it at one lack INR but even then he is not getting the desired response.
i have fired about 14 rounds from it and the weapon wasn't able to leave a mark.
Its much better to go for an IOF .32 than an Arminius.
Regards
Rudra
POWER RISES FROM THE BARREL OF A GUN
- Risala
- Shooting true
- Posts: 916
- Joined: Fri Mar 02, 2007 12:24 am
- Location: Khurpatal
Re: ARMINIUS .32 revolver
Arminus has always been very popular in India,value for money hand
guns,when one compares there price with a S & W,Colt,Ruger etc.
Sanjay
guns,when one compares there price with a S & W,Colt,Ruger etc.
Sanjay
- Rudra
- Almost at nirvana
- Posts: 116
- Joined: Sat Aug 11, 2007 2:50 am
- Location: Patna (Bihar)
Re: ARMINIUS .32 revolver
"compares there price with a S & W,Colt,Ruger etc.'
They cannot be compared with these models.
They cannot be compared with these models.
-
- Almost at nirvana
- Posts: 232
- Joined: Tue Apr 03, 2007 12:25 am
- Location: Kolkata
- Contact:
- mundaire
- We post a lot
- Posts: 5410
- Joined: Mon May 22, 2006 5:53 pm
- Location: New Delhi, India
- Contact:
Rudra,Rudra";p="29451 wrote: In my opinion the revolvers are not very durable and are also cheap.
A guy here is ready to sell it at one lack INR but even then he is not getting the desired response.
i have fired about 14 rounds from it and the weapon wasn't able to leave a mark.
Its much better to go for an IOF .32 than an Arminius.
Regards
Rudra
My paternal uncle has one of these (.32 S&W Long), and I have "tried it out" several times - these are good revolvers, much better IMHO than the turn of the century Webley designs. As to accuracy, it's as good (or as bad) as any other similar sized revolver... keep in mind these are NOT intended to be target grade guns and are intended PURELY for self defence with expected range of typical use of up to 15 or so yards... at which range it would not be difficult at all to hit a man sized target...
As to their reputation as NOT being strudy enough, well it's a load of hogwash! This rumour stems purely from the use of unconventional materials in the manufacture of this gun, and has no basis on any documented evidence whatsoever. If unconventional materials made guns fragile, then Glock and H&K pistols would be blowing up in the faces of their users all the time... as they use polymers extensively in their construction!!
As to the makers repute, well Weihrauch, Germany is not a "known" brand name on the handgun scene BUT they have an excellent overall reputation for their standards of quality. As Sanjay says this is an EXCELLENT bargain revolver in the Indian market. I would happily pick one of these up for circa 1 lac in stead of either the IOF revolver OR the more much much more expensive American or British made revolvers...
My $0.02....
Cheers!
Abhijeet
Like & share IndiansForGuns Facebook Page
Follow IndiansForGuns on Twitter
FIGHT FOR YOUR RIGHTS - JOIN NAGRI NOW!
www.gunowners.in
"Political tags - such as royalist, communist, democrat, populist, fascist, liberal, conservative, and so forth - are never basic criteria. The human race divides politically into those who want people to be controlled and those who have no such desire." -- Robert Heinlein
Follow IndiansForGuns on Twitter
FIGHT FOR YOUR RIGHTS - JOIN NAGRI NOW!
www.gunowners.in
"Political tags - such as royalist, communist, democrat, populist, fascist, liberal, conservative, and so forth - are never basic criteria. The human race divides politically into those who want people to be controlled and those who have no such desire." -- Robert Heinlein
-
- Old Timer
- Posts: 2653
- Joined: Sat Jun 03, 2006 12:43 am
- Location: UK
Re: ARMINIUS .32 revolver
The modern Arminius revolvers are pretty good......I`m just wondering if there is a mix-up with pre-WWII Arminius revolvers which were NOT made by Weihrauch and were ( and still are ) cheap junk
- mundaire
- We post a lot
- Posts: 5410
- Joined: Mon May 22, 2006 5:53 pm
- Location: New Delhi, India
- Contact:
Nopes, these ones floating around are alloy framed ones which I'm pretty certain are 1970's-80's vintage....Grumpy";p="29482 wrote: The modern Arminius revolvers are pretty good......I`m just wondering if there is a mix-up with pre-WWII Arminius revolvers which were NOT made by Weihrauch and were ( and still are ) cheap junk
Cheers!
Abhijeet
Like & share IndiansForGuns Facebook Page
Follow IndiansForGuns on Twitter
FIGHT FOR YOUR RIGHTS - JOIN NAGRI NOW!
www.gunowners.in
"Political tags - such as royalist, communist, democrat, populist, fascist, liberal, conservative, and so forth - are never basic criteria. The human race divides politically into those who want people to be controlled and those who have no such desire." -- Robert Heinlein
Follow IndiansForGuns on Twitter
FIGHT FOR YOUR RIGHTS - JOIN NAGRI NOW!
www.gunowners.in
"Political tags - such as royalist, communist, democrat, populist, fascist, liberal, conservative, and so forth - are never basic criteria. The human race divides politically into those who want people to be controlled and those who have no such desire." -- Robert Heinlein
-
- Shooting true
- Posts: 788
- Joined: Wed Dec 27, 2006 11:53 pm
- Location: DELHI
Re: ARMINIUS .32 revolver
........
Last edited by art_collector on Fri Nov 23, 2007 3:42 pm, edited 1 time in total.