A tool of interest to muzzle loaders

Posts related to rifles.
Post Reply
User avatar
Mark
Veteran
Veteran
Posts: 1147
Joined: Sat Jun 03, 2006 10:37 am
Location: Middle USA

A tool of interest to muzzle loaders

Post by Mark » Mon Jun 04, 2007 5:38 am

First off, I have never used one of these even though they have been around forever. It is a tool that forms little cups out of aluminum pop cans that you put an ordinary cap gun paper cap into, and presto! you get a size #11 percussion cap!

Image

http://www.lockstock.com/prodinfo.asp?number=FRTC1000

If anyone has a traditional muzzle loader that uses a #11 cap, this with a bullet mould and a pound of powder will provide a LOT of economical shooting!
"What if he had no knife? In that case he would not be a good bushman so there is no need to consider the possibility." H.A. Lindsay, 1947
Top
For Advertising mail webmaster
User avatar
Pran
Eminent IFG'an
Eminent IFG'an
Posts: 995
Joined: Sat Nov 25, 2006 2:06 pm
Location: Bengaluru, Karnataka

Re: A tool of interest to muzzle loaders

Post by Pran » Mon Jun 04, 2007 7:41 am

Nice one Mark.Do you cast your own sabots?

Pran
"A gun is a tool, Marian. No better, no worse than any other tool. An axe, a shovel, or anything. A gun is as good or as bad as the man using it."
Top
User avatar
Mark
Veteran
Veteran
Posts: 1147
Joined: Sat Jun 03, 2006 10:37 am
Location: Middle USA

Re: A tool of interest to muzzle loaders

Post by Mark » Mon Jun 04, 2007 10:42 am

No. I don't use sabots in muzzle loaders at the moment, though that may change in the future but for right now I either use conical slugs or round balls that have a cloth patching.
"What if he had no knife? In that case he would not be a good bushman so there is no need to consider the possibility." H.A. Lindsay, 1947
Top
Post Reply

Return to “Rifles”