Scope for Czech Brno .22

Posts related to rifles.
Post Reply
LAWMSIAMA
Learning the ropes
Learning the ropes
Posts: 32
Joined: Thu May 10, 2012 12:02 am

Scope for Czech Brno .22

Post by LAWMSIAMA » Tue May 15, 2012 3:43 am

Right now I install a Bushnell 7X32 scope, what would be the best for the rifle if I am using
1. Indian made .22 rounds
2. Imported .22 rounds

For Advertising mail webmaster
Katana
Veteran
Veteran
Posts: 1004
Joined: Mon Jan 25, 2010 12:22 pm
Location: Gujarat

Re: Scope for Czech Brno .22

Post by Katana » Tue May 15, 2012 8:19 am

7x32 is an odd configuration for a scope. 4x32 is more likely! Best would be to avoid using a scope on a .22. The effective flat trajectory is not going to be more than 55 meters. At that range it better to use your iron sights.

Assuming you use it competitively, you would not be able to use optical sights. On the other hand if you use it in the field, your target is not going to be static and with an objective diameter of 32mm, the target will have slipped out before you can even acquire it. So the only application left where you could use a scope on a .22 is for silhouette shooting!

As concerns the makes of ammo, it's a personal choice. Despite people cussing the IOF/KF I think, in the present circumstances, it's just fine.
Justice alone is the mainstay of government and the source of prosperity to the governed, injustice is the most pernicious of things; it saps the foundations of the government and brings ruin upon the realm - Sher Shah Sur, Sultan-ul-Adil.

kaugustine
Fresh on the boat
Fresh on the boat
Posts: 9
Joined: Fri Jan 01, 2010 12:31 pm
Location: aizawl

Re: Scope for Czech Brno .22

Post by kaugustine » Sun May 20, 2012 9:17 pm

In .22 rimmed fire Rifle, most of the gun writers has suggested to use the scope which is not more than 4X Power (like 4X20 or 4X32) because of it limited range. But I have used the Leapers scope 3-9X32 AO in my .22 Brno Model 2E Rifle, the accuracy is quite satisfied, it is half inch grouping in the bulleyes at the range of 50 metres with Lapua standard rounds, half inch grouping at the range of 75 metres with Winchester super X hiper velocity hollow point rounds. It shows that the Hi or Hiper velocity rounds are much flatter than the standard round one. Selection of the scope has to be very curious as well as selection of ammo. I have experience that single brand of the ammo should be used once which is zeroing the rifle with. KF or Indian made ammo has no consistency in accuracy as well as velocity. Best of luck on your selection.

Regards

Kaugustine

Pritu79
On the way to nirvana
On the way to nirvana
Posts: 68
Joined: Wed May 27, 2009 1:43 pm

Re: Scope for Czech Brno .22

Post by Pritu79 » Thu May 24, 2012 9:14 am

A 7x32 is an excelent choice....... 7x magnification is more than sufficient, because after increasing an decreasing the magnification on all my variable scopes some how i have setteled on 6x and a fixed power scope is more rugged and durable due to less moving parts....some might find this debatable.
As far as amo is concerned, i have used an .22lr extensively and found it to have decent accuracy at 125yard which is dependent on the amo and rifle you use. i am quite fond of the winchester super X myself, at 125yards you'll get a migrange rise roughly of around 1.25"-1.5" which is not bad......this was from a Krico single shot 24" barell.

cheers

User avatar
brihacharan
Old Timer
Old Timer
Posts: 3112
Joined: Fri Jan 22, 2010 3:33 pm
Location: mumbai

Re: Scope for Czech Brno .22

Post by brihacharan » Thu May 24, 2012 10:27 am

> [quote="Katana"]4x32 is more likely! Best would be to avoid using a scope on a .22. The effective flat trajectory is not going to be more than 55 meters. At that range it better to use your iron sights.
> As concerns the makes of ammo, it's a personal choice. Despite people cussing the IOF/KF I think, in the present circumstances, it's just fine. :agree:

> It would be best if you could 'zero in' with IOF/KF ammo at 50 metres to get 1/2" groups consistenty.
> This way you can hit targets with accuracy from 35 metres to 75 metres by holding 1/2" to 3/4" high or low as per the distance.
> You can use a OHP marking Pen to indicate this - Mark a Blue Dot on the elevation dial for 35 metres / Green Dot for 50 metres & Red Dot for 75 metres while zeroing the scope.
> So depending on the distance of the target - just turn the elevation dial to suit the distance.
> I've done this successfully on my 30.06 with 180gr bullets for 70 metres / 150 metres / 250 metres.
Cheers
Briha

MoA
Veteran
Veteran
Posts: 1644
Joined: Fri Apr 11, 2008 8:08 pm

Re: Scope for Czech Brno .22

Post by MoA » Fri May 25, 2012 12:58 pm

As for a scope, use what ever you want. I use a 4-24x on my .22.

Your bullet drop between 50 and 75 meters is going to be a lot more than 0.75 inches. Between 50 and 100 meters, I typically see a 4 inch drop with CCI standards.

You can shoot a .22 out to about 200 meters, but it needs a fair amount of skill.

StampMaster
One of Us (Nirvana)
One of Us (Nirvana)
Posts: 337
Joined: Wed Feb 08, 2012 12:36 pm
Location: Hyderabad, Bangalore, Dubai UAE

Re: Scope for Czech Brno .22

Post by StampMaster » Sat Sep 01, 2012 12:07 am

from my previous reading experts have suggested to zero the .22 scope at 25 yards so it would be almost or near zero at 5 yards and 1inch high at 50 yards.

In regards to the scope I think investing in a low cost 3-9X, and 30-40mm scope is good. Mine (currently using) is something powerful 6-24x, 40mm.
”Criminals love gun control; it makes their jobs safer.”

Post Reply