need help

[talha]

hello i need some help about the replacement of the simple iron sights to fiber optics sights on my diana 350 magnum .177. can it be possible and where they are available..?

[shariq]

hello talha i have seen one rear fibre optic sight contact me regards

[mercury]

i have a 350 classic TO6. the front sight is a one piece plastic mould. which i think doubles as a muzzle break. any ways it is held down to the barrel with a very tiny screw. i have not tried to fool around with it as i am worried i will not be able to centre the sight again. doubt if there would be any indent or threads on the barrel.

to answer your question, i guess it could be done. if the tiny screw need only be tightened to hold it to the barrel, easy for you.....only diffuculty true centre. if there is some kind of indent for the screw, easier still and true centre!!

Shariq, any idea where i can get oem seal and breach washer for the classic??

[shariq]

i have a 350 classic TO6. the front sight is a one piece plastic mould. which i think doubles as a muzzle break. any ways it is held down to the barrel with a very tiny screw. i have not tried to fool around with it as i am worried i will not be able to centre the sight again. doubt if there would be any indent or threads on the barrel.

to answer your question, i guess it could be done. if the tiny screw need only be tightened to hold it to the barrel, easy for you.....only diffuculty true centre. if there is some kind of indent for the screw, easier still and true centre!!

Shariq, any idea where i can get oem seal and breach washer for the classic??

@ mercury contact This thread has been edited for violation of Indian For Guns policy as stated in the Announcements forum regards

[fantumfan2003]

I have a set of Diana fibre optic sights, both rear and front. This is an original set. PM me if you want it.

M.

hello i need some help about the replacement of the simple iron sights to fiber optics sights on my diana 350 magnum .177. can it be possible and where they are available..?

[mercury]

shariq, not too impressed with tti seals.

the diana oem seals are really good.

fantumfun any ideas??

also fantumfun , do the front sights you have have a shroud?? the TO6 has a shroud and i wish they had an option to remove the shroud, as i like them open as in the earlier classic models.

[fantumfan2003]

The sights i have are like the ones you see here

http://www.pyramydair.com/s/m/Diana_RWS ... rifle/1041

I think I have a spare Diana blue seal which will fit your Diana. Will check and revert

M.

shariq, not too impressed with tti seals.

the diana oem seals are really good.

fantumfun any ideas??

also fantumfun , do the front sights you have have a shroud?? the TO6 has a shroud and i wish they had an option to remove the shroud, as i like them open as in the earlier classic models.