Below two issues happened today any help suggestions are welcome. Also anyone aware of Feinwerkbau service center or repair man in Kolkata
Issue 1
Today when my daughter was loading her rifle ,the rifle bolt was open but the pallet released and fell out just in front of her face... And from rifle cylinder smoke was coming while the pallet was released...
Issue 2
Earlier her rifle was in dry mode .. My hand or finger were not touching the trigger or grip but the trigger was released..
Feinwerkbau issue. Help needed
-
Bau003
- Learning the ropes
- Posts: 17
- Joined: Sat Jan 13, 2024 6:05 pm
-
Shivakr
- Almost at nirvana
- Posts: 121
- Joined: Sat Nov 17, 2018 6:09 pm
Re: Feinwerkbau issue. Help needed
Check ur DM
-
Bau003
- Learning the ropes
- Posts: 17
- Joined: Sat Jan 13, 2024 6:05 pm
Re: Feinwerkbau issue. Help needed
Posting the solution for everyone
1. The cylinder has issues back leakage causing reverse air flow
2. Trigger weight was reduced considerably causing false triggering
Cylinder need to be replaced as solution for 1st
Screw 46 refer manual for details of it need to be tightened by moving it anti clock wise
1. The cylinder has issues back leakage causing reverse air flow
2. Trigger weight was reduced considerably causing false triggering
Cylinder need to be replaced as solution for 1st
Screw 46 refer manual for details of it need to be tightened by moving it anti clock wise
-
Able
- On the way to nirvana
- Posts: 78
- Joined: Tue Feb 06, 2018 7:44 pm
Re: Feinwerkbau issue. Help needed
Good to know that you found the solution and post it here.
By any chance you could point me where to buy O-ring sets for Feinwerkbau 800?
By any chance you could point me where to buy O-ring sets for Feinwerkbau 800?