Page 1 of 1
Hill pump filling problem.
Posted: Sun Jun 21, 2020 9:54 am
by Km82
I have recently purchase a hill pump. But whenever i pump my walther dominator 1250 above 100 bar, there is a leakage in the connection between the end of hose and the adapter. Morever, when i bleed the pump when done, the entire air from the gun cylinder also gets emptied.Please help, i am a novice in this area and this is my first Pcp gun.
Re: Hill pump filling problem.
Posted: Mon Jun 22, 2020 7:45 pm
by andy_65_in
Better ask some walther guy...the pcp had some issues as i read..could be a leakage in the pcp fill probe itself
Re: Hill pump filling problem.
Posted: Mon Jun 22, 2020 10:55 pm
by Km82
Surely i will do that. However in my case, both the gun and the pump is brand new. It happended in my first try.
Re: Hill pump filling problem.
Posted: Wed Jun 24, 2020 8:33 pm
by andy_65_in
Km82 wrote: ↑Mon Jun 22, 2020 10:55 pm
Surely i will do that. However in my case, both the gun and the pump is brand new. It happended in my first try.
check are you using the correct female/male filling foster or not...it might be leaking...this is what connects the pump to the pcp
Re: Hill pump filling problem.
Posted: Wed Jun 24, 2020 9:11 pm
by 4X4
You can contact your seller and explain him the issue. Make a video recording of it and send to seller.
Also if you send the query to Hill company directly, they will surely help you with the solution to your problem. No harm in trying to ask them.
Re: Hill pump filling problem.
Posted: Thu Jun 25, 2020 12:51 pm
by Km82
Thanks for your response. I have already taken up the matter with the seller. Reply from the seller is being awaited.