Indians For Guns

I hav a px100 with a problem. Air filling is working perfect but despite hving good pressure of 150 bar the power has reduced drastically. I replaced the seal of the regulator inside the cylinder due to leakage of air. The problem started only after the replacement. Any help would be appreciated.


Sent from my iPhone using Tapatalk

Hi,
1. Which seal did you replace?
2. Did you remove the barrel while replacing?
Rgds
R

prashantchandila wrote: ↑

Tue Dec 10, 2019 12:45 pm

I hav a px100 with a problem. Air filling is working perfect but despite hving good pressure of 150 bar the power has reduced drastically. I replaced the seal of the regulator inside the cylinder due to leakage of air. The problem started only after the replacement. Any help would be appreciated.


Sent from my iPhone using Tapatalk

First - there is no regulator in this rifle. It is direct flow rifle.
What you call "regulator" is a valve. If already posted it here:
To find the place of air leakage unscrew the rifle stock, pump up the air cylinder so that it has air pressure, put in a container with water. You'll see air bubbles.
After changing all the seals I still had this problem. Air was going out through the thread between receiver and brass chamber at the end of air cylinder.
To solve it I used Thread Seal Teflon Tape. Worked for me.

Hope it helps

prashantchandila wrote: ↑

Tue Dec 10, 2019 12:45 pm

I hav a px100 with a problem. Air filling is working perfect but despite hving good pressure of 150 bar the power has reduced drastically. I replaced the seal of the regulator inside the cylinder due to leakage of air. The problem started only after the replacement. Any help would be appreciated.


Sent from my iPhone using Tapatalk

If the air leakage problem is solved make sure that you had aligned the Transfer Port correctly. This is essential and PH PCP has no automatic alignment of barrel correctly. They overlooked this and yet it is not a difficult thing to incorporate in the design

GNV wrote:

prashantchandila wrote: ↑

Tue Dec 10, 2019 12:45 pm

I hav a px100 with a problem. Air filling is working perfect but despite hving good pressure of 150 bar the power has reduced drastically. I replaced the seal of the regulator inside the cylinder due to leakage of air. The problem started only after the replacement. Any help would be appreciated.


Sent from my iPhone using Tapatalk

If the air leakage problem is solved make sure that you had aligned the Transfer Port correctly. This is essential and PH PCP has no automatic alignment of barrel correctly. They overlooked this and yet it is not a difficult thing to incorporate in the design

Yes this alignment of barrel was the main problem. Anyways thanks to all the members for their replies.


Sent from my iPhone using Tapatalk