Page 1 of 1
Help Needed to solve Auto Fire in IHP 35 in .22
Posted: Sun Dec 21, 2014 1:32 pm
by noviceairgunner
Dear Friends,
While tuning my IHP i think i Have over worked the piston sear and Trigger Blade...Now its become very dangerous sometimes its auto fire...
I tried to solve it trying to file the piston sear trigger engagement area back to normal..but failed to obtain optimum result..
please suggest some remedy so my rifle regain its safe status...
Waiting for your replies
Re: Help Needed to solve Auto Fire in IHP 35 in .22
Posted: Mon Dec 22, 2014 3:24 pm
by crosshair
Dear noviceairgunner,
Please post pictures of the parts in question. The quick reply is: The safest thing to do is to change both parts.
Regards
Re: Help Needed to solve Auto Fire in IHP 35 in .22
Posted: Mon Dec 22, 2014 5:00 pm
by bennedose
About 1 year ago my SDB 50 started auto-firing. I had discussed that on a thread in this forum.
I had thick blobs of brass deposited on the trigger sear as well as the piston sear and them filed them off painfully and slowly till everything was fine. An earlier attempt at using brass weld only on the trigger failed. Contrary to my expectation, a thick enough blob of brass which did not end in a razor sharp edge worked, despite brass being much softer than steel.
Here is a link to the last post of that thread which has useful inputs from many people.
http://indiansforguns.com/viewtopic.php ... 15#p207915
I must point out that I retired that SDB 50 after firing a further 1000 shots or so after the repair. It still works but the sights suck, so the rifle is in storage as of now
Re: Help Needed to solve Auto Fire in IHP 35 in .22
Posted: Mon Dec 22, 2014 5:15 pm
by bennedose
Here is what the initial blob of brass looked like (click on image)
But I filed it too much and it failed when it reached the appearance below. I had to get more brass deposited and left a "plateau" rather than a sharp peak
The following worked
http://indiansforguns.com/download/file.php?id=10033
Re: Help Needed to solve Auto Fire in IHP 35 in .22
Posted: Tue Dec 23, 2014 12:05 pm
by brihacharan
> Well done bennedose
> That's the only way to solve the problem - However one's hand-skills will be put to test in arriving at the right degree of angle
Briha
Re: Help Needed to solve Auto Fire in IHP 35 in .22
Posted: Tue Dec 23, 2014 8:02 pm
by Basu
There are things that you can do as being suggested earlier.
If you are not aware as to how to do that ..better get new piston and trigger from IHP.
They will send those to you against payment.
Please contact them over phone or by mail.
Needless to mention....IHP is a very nice gun if tuned properly.
Basu
