Loose plastic cap at the back end of IHP national 35

abulkazad · Post by **abulkazad** » Sun Aug 31, 2014 7:13 pm

I bought IHP national 35 0.177 recently. Today while I was looking at, I found the plastic cap in the backside of rifle is loose and not at attached to it.

Is this normal? Shall I use some glue to fix it?

Please advise.

Thanks

Basu · Post by **Basu** » Mon Sep 01, 2014 10:58 am

Dear abul,
Previously it was made of iron.
It does not have anything to do with power or accuracy.
It is simply cosmetic.
Do not glue it as it is meant for free fit.
Have they used 'O' ring washer as breech seal ??

Basu

brihacharan · Post by **brihacharan** » Mon Sep 01, 2014 11:09 am

Hi abulkazad,
> The plastic rear cap is an original fitting - which sometimes works loose....
> Its only a cosmetic part - not functional....
> You may fix it with rubber solution - easy to remove while servicing or tuning the AR....
Briha

abulkazad · Post by **abulkazad** » Mon Sep 01, 2014 7:15 pm

Thank you brothers.

Indians For Guns

Indians For Guns

Loose plastic cap at the back end of IHP national 35

Loose plastic cap at the back end of IHP national 35

Re: Loose plastic cap at the back end of IHP national 35

Re: Loose plastic cap at the back end of IHP national 35

Re: Loose plastic cap at the back end of IHP national 35