Page 1 of 1
Need 11 mm rail for ihp
Posted: Mon Mar 17, 2014 6:19 pm
by viraniparvez
Dear all
i urgently need 11 mm rail for fitting center-point scope on Ihp
can some one pls help
i wasn't able to get it produced here as there are not professional ppl here
thanks for guidance and suggestions in advance
Re: Need 11 mm rail for ihp
Posted: Tue Mar 18, 2014 3:17 pm
by bennedose
Re: Need 11 mm rail for ihp
Posted: Tue Mar 18, 2014 3:42 pm
by brihacharan
> These appear to be OK...
> However from the image displayed there does not appear any holes drilled for fixing it on to the receiver....Perhaps that's been left for the individual to get it done to suit his requirement....
> Hence extreme care should be taken while drilling the holes & centering it as otherwise the scope will go out of alignment with the bore!
Briha
Re: Need 11 mm rail for ihp
Posted: Tue Mar 18, 2014 4:45 pm
by chetan4shooting
i want one for my indian made side lever .22
Re: Need 11 mm rail for ihp
Posted: Thu Apr 24, 2014 6:33 pm
by estousandy
viraniparvez wrote:Dear all
i urgently need 11 mm rail..
How about this?
http://www.dx.com/p/battleaxe-ak-qd-qui ... 1kKU_mSySo
With a bit of grinding & base fabrication, it can take a 11 mm attachment without any receiver drilling. Just fix it aligned onto the stock.
Re: Need 11 mm rail for ihp
Posted: Thu Apr 24, 2014 7:08 pm
by AnandNair
you will get picatinny rails with curved bottom in both dx and aliexpress, with holes drilled and screws. that will be a better idea than normal 11mm dovetails.
something similar to this
http://www.aliexpress.com/item/Shotgun- ... 55568.html
or
http://www.dx.com/p/aluminum-alloy-gun- ... 1kXkKaOVgE
You can try coldweld epoxy / jbweld and you can find ways/location to drill holes and fixing etc here :
http://target-tune.in/international/pro ... mount.html