Indians For Guns

Dear Members can anybody tell me where I can find original IHP National 35 model .22 cal. air rifle spring and fibre washer. I am living in bhopal and indore where I can't find the original spring and fibre washer. recently visited an air gun shop in Mumbai at Abul Rehman street and there also got disappointed. I hav also got 25 model IHP .22 cal I tuned it with G-Smith Spring and G-Smith leather washer but not stisfied by the performance of G-Smith as trigger got hard....Ma question with all the members is which is the best suited spring and washer available for IHP 35 model in India..and if fiber washer (piston seal ) available in India .........thanks

You may do PM to Kezar husen bandukwala, who happens to be our member and also a gun dealer in Indore.
He is a very helpful guy.

Basu

Thanks Basu but I already met him personally he dont have national spring and fiber washer

samirforguns wrote: Thanks Basu but I already met him personally he dont have national spring and fiber washer

> Why don't you contact IHP factory directly & request them.
> The contact person is Mr. Makhija - Mobile No: 09898075543
Briha

There are various manufacturers of piston seals but regarding the spring CHEROKEE is the best indian made spring.

I am in disagreement with adilmaroof.
Cherokee is a spring with very high vibration,due to its carbon content.
It is worst if you use 3.2 mm 37 coil,called 35.
For IHP 35 ,you may go ahead max for 3 mm 37 coil,called 27 .
For IHP 25 ,it is the stock spring with wire dia 3 mm with 29 coil.
In higher segment ,you may go for 31 coil ,2.8 mm Diana spring from Target Tune India.
Choice is yours.

Basu

buy precihole spring and washer from aimco, both are good and better than ihp factory spring and washer.gsmith spring is good one in terms of power but it increases noise to a great extent and also trigger will be more hard to pull.more over precihole spring has better fitting to spring guide than factory one.

Basu wrote:I am in disagreement with adilmaroof.
Cherokee is a spring with very high vibration,due to its carbon content.
It is worst if you use 3.2 mm 37 coil,called 35.
For IHP 35 ,you may go ahead max for 3 mm 37 coil,called 27 .
For IHP 25 ,it is the stock spring with wire dia 3 mm with 29 coil.
In higher segment ,you may go for 31 coil ,2.8 mm Diana spring from Target Tune India.
Choice is yours.
Basu

> Good suggestion Basu
Briha

najad wrote:buy precihole spring and washer from aimco, both are good and better than ihp factory spring and washer.gsmith spring is good one in terms of power but it increases noise to a great extent and also trigger will be more hard to pull.more over precihole spring has better fitting to spring guide that factory one.

Precihole Piston Seal is good for IHP & I think cost you not more then Rs. 100/-
When I installed Precihole spring with seal in my .177 IHP 35 it was very smooth to cock, less vibration ,very smooth to shot & required less trigger pull only I was getting velocity around 550 fps but I was very happy with overall performance

spring costs rs.350 and seal rs.200
http://aimco.co.in/category/64-spares.aspx

Basu wrote: Cherokee is a spring with very high vibration,due to its carbon content.
It is worst if you use 3.2 mm 37 coil,called 35.
For IHP 35 ,you may go ahead max for 3 mm 37 coil,called 27 .
For IHP 25 ,it is the stock spring with wire dia 3 mm with 29 coil.
In higher segment ,you may go for 31 coil ,2.8 mm Diana spring from Target Tune India.

I know whom to bug with all the questions regarding Air Rifle Tuning , when I will be tuning a Air Rifle


Regards

F-N-Five-Seven

Thank u all for ur suggestions I will try Prateek_mahale's suggestion of using percihole spring and washer...

Dr. Frds, I recently, I upgraded my IHP 35 spring with Precihole Spring and washer, it works smoothly. The trigger is soft and also cocking effort. Thanks for all of your advise.

IHP springs are pretty good too.

snIPer wrote:IHP springs are pretty good too.

It suits best with IHP.

Basu