Indians For Guns

This is my DIY Field Target
Made by some vest material thick metal plate with one inch hole as front panel
Kill zone is 1 “ Dia , Height if 1 Feet
Tested at 20 Yards with my Pegasus Air Rifle .177 ,12 ft-lbs
Please see the video file size is 18 MB



Also tested at 30 Yards working perfectly

Any suggestions

You should have made the rear panel collapse independently when the pellet strikes it so you know when you've gone through and when you haven't Otherwise the setup looks great I'm looking at making a good pellet trap/target set with some scrap metal, wood and books once I get a Pegasus

You have not seen the video properly I made this FT collapse only when pellets hit the kill zone
In the video I hit the first two shot on the kill zone & entire unit collapses but when I hit third shot (deliberately) on the front metal plat entire unit remain stable not collapse

Ah My mistake then.