Indians For Guns

Hi Guys,

I just bought two days back an Amy95 airrifle from Aimco, Calcutta. Since yesterday nite, it is not firing pellets. I had fired maybe a dozen pellets and this happened. It remains stuck in its slot. I break the barrel just fine and the impact is also the same on squeezing the trigger... I oiled, cleaned the barrel, etc... but no use. After squeezing off the shot, when I open the barrel, all around the hole where I fix the pellet, there is residue (probably rubber)

Hey, I checked by dipping the muzzle in bucket of water, putting a pellet in and firing... there are no bubbles, so the air is not expelled through the muzzle. I then submerged the gun till trigger and tried to fire a pellet... still no bubbles... so there is no air escaping till that level... has the spring cylinder gone bad ?

Word of advice, don't buy Aimco... the day i recd, packaging is good... but the rivet just below the barrel on which it swings when I pump it before the shot was not fixed in place and moves out. I have to hold it in place before pumping the barrel or firing the shot. Looks good but typical cheapskate local goods... looks great but no excellence in the products.

Living in Mumbai, sending it back and paying for courier both ways and also octroi will cost me about Rs.1800/- so, cannot do that...

Any help would be very much appreciated.

Regards,


Naren

Dear brother may be your air rifle's piston seal is leaking if you dont know how to repair it then go to your nearest gunsmith he will done the job

Hi,

Thank you for your response.

How do I confirm that the piston seal is leaking? This is a gun barely 2 days old and shot not more than 10 pellets. How could this have happened?

Regards,


Naren

It has been with you for two days, it could have been with someone else before it.

Who knows how it happened may be some manifacturing defect, poor quality part or may be an error on your end, no one on this forum will be able to answer this.

I would suggest take it a gun smith or the dealer. Putting it in water was not a smart move. The more you play with it more dammage will happen.

Hi,

Thank you for your response.

I asked your opinion as to why this could have happened since if it could have been an error on my part then I can avoid repeating it.

Can anyone recommend a reliable gunsmith in Mumbai?

Many thanx for your help

Regards,


Naren

The process for an air gun is usually simple, once you get it fixed please ask the gunsmith for advice.