Page 1 of 1
break barrel help needed
Posted: Thu Jan 13, 2011 10:14 pm
by savage
hey guyz i own many airguns but my fav has been my old savage 65 mod .22 break barrel but currently its in a dire state and its not loading my local airgunsmith wants to get a new piston for it ,kindly advice....
I live near nagpur
Re: break barrel help needed
Posted: Fri Jan 14, 2011 12:50 am
by hamiclar01
can you describe what exactly happens when you load and fire a pellet?
Re: break barrel help needed
Posted: Fri Jan 14, 2011 8:06 pm
by savage
hamiclar01 wrote:can you describe what exactly happens when you load and fire a pellet?
see as you go to load the bar that pushes the spring back slips and gets locked there.............. what should i do?
to remove the bar i have to take out the stock remove the barrel and push out the bar outside cause its stuck by the large circular oval shaped peice that gets pushed back..................its also started to rust now that it hasnt been used since long
Re: break barrel help needed
Posted: Fri Jan 14, 2011 8:16 pm
by dr.jayakumar
just disassemble and post picture.only if we see we can guide you.
Re: break barrel help needed
Posted: Sat Jan 15, 2011 1:10 am
by savage
sir as u told i went and diss assembled it but when i slowly tried to load it ,it was successful and now its not giving me much of a problem thnx
Re: break barrel help needed
Posted: Sat Jan 15, 2011 9:36 am
by dr.jayakumar
good,some time you got to take some risk!!!
Re: break barrel help needed
Posted: Sat Jan 15, 2011 11:38 am
by savage
that is absolutely correct