Page 1 of 1

Electric and Electronic component servicing

Posted: Mon Jun 06, 2016 2:32 pm
by TheThirdEye
I am an Embedded Engineer and would like to see some challenging equipment/component servicing in Armoury Industries.

I am ready to help out people facing issues with their gears from electronic point of view.

Re: Electric and Electronic component servicing

Posted: Mon Jun 06, 2016 3:30 pm
by mundaire
Can you help fix up a couple of shot out Chronographs? ;) :lol:

Cheers!
Abhijeet

Re: Electric and Electronic component servicing

Posted: Mon Jun 06, 2016 3:49 pm
by TheThirdEye
If there is any measurement issue or data transmission issue, I can.

Re: Electric and Electronic component servicing

Posted: Mon Jun 06, 2016 5:22 pm
by mundaire
I think you misunderstood my post... Both of these chronographs have a bullet hole (from a .30-06 no less!) through them. My post was in a lighter vein, though if you can truly help in getting them working again, I'd be mighty pleased indeed! :D

Cheers!
Abhijeet

Re: Electric and Electronic component servicing

Posted: Mon Jun 06, 2016 5:34 pm
by TheThirdEye
Ya I doubted it by seeming the last 2 smilies... but without the clear picture of what you mean... I couldn't reply that way...

Sent from my XT1022 using Tapatalk

Added in 31 seconds:
[SMILING FACE WITH OPEN MOUTH]

Sent from my XT1022 using Tapatalk

Re: Electric and Electronic component servicing

Posted: Fri Jun 10, 2016 4:58 pm
by goodboy_mentor
TheThirdEye wrote:I am ready to help out people facing issues with their gears from electronic point of view.
In order to unlock from particular content provider, so that one may receive signals from practically any satellite above in the sky, are you familiar with tinkering with satellite TV set top boxes or their firmware? Similarly also making cheap DIY DVB S2 receivers and connecting to raspberry pi, so that one may receive signals from practically any satellite above in the sky?

Re: Electric and Electronic component servicing

Posted: Tue Jun 14, 2016 8:03 pm
by TheThirdEye
I have used raspberry pi and audrino board. But did not have experience on satellite communications

Sent from my XT1022 using Tapatalk