hi, I m facing a problem with my 5 year old ihp. 22 air rifle(approx1500 shots). The barrel locking piece has worn out causing barrel droop and a slight leak. I'm thinking of replacing it by myself. I tried loosening the screw but it din't unscrew completely. Please somebody teach me how to replace it, the way to detach it and put back the a new one back. I would like to know if I could repair the current one and use it.
Thank you
DIY barrel lock ihp35
-
abii
- Learning the ropes
- Posts: 29
- Joined: Wed Aug 31, 2011 8:23 pm
- Location: davangere
DIY barrel lock ihp35
You do not have the required permissions to view the files attached to this post.
-
brihacharan
- Old Timer
- Posts: 3112
- Joined: Fri Jan 22, 2010 3:33 pm
- Location: mumbai
Re: DIY barrel lock ihp35
Hi abii,
> The problem is that the locking 'lug' has worn out - which means that this condition will cause improper locking of the barrel & also cause leakage, resulting in loss of velocity & possibly accuracy.
> The only way to rectify this is to contact IHP & get a new barrel locking lug + spring & screws ...and fit them.
> Go to IHP website and request them for these parts...they will oblige...
Good Luck!
Briha
> The problem is that the locking 'lug' has worn out - which means that this condition will cause improper locking of the barrel & also cause leakage, resulting in loss of velocity & possibly accuracy.
> The only way to rectify this is to contact IHP & get a new barrel locking lug + spring & screws ...and fit them.
> Go to IHP website and request them for these parts...they will oblige...
Good Luck!
Briha
-
abii
- Learning the ropes
- Posts: 29
- Joined: Wed Aug 31, 2011 8:23 pm
- Location: davangere
Re: DIY barrel lock ihp35
Thank you very much Sir. Would you please brief me the procedure to change the lug because I tried hard to loosen the screw but it has stuck. I'm not sure about the mechanism inside and don't want to ruin the threading and all.
-
brihacharan
- Old Timer
- Posts: 3112
- Joined: Fri Jan 22, 2010 3:33 pm
- Location: mumbai
Re: DIY barrel lock ihp35
> If you have problems regarding loosening the screw - don't attempt it, you may end up damaging the mechanism...abii wrote: Thank you very much Sir. Would you please brief me the procedure to change the lug because I tried hard to loosen the screw but it has stuck. I'm not sure about the mechanism inside and don't want to ruin the threading and all.
> My advice would be - after acquiring the parts from IHP, take them to a gun mechanic attached to any arms dealer in your area & get it done...
Good Luck!
Briha