Page 1 of 1
Finished, first knife project. (Update)
Posted: Thu Dec 14, 2017 11:37 pm
by vjisaac
Finally finished giving final touches, hope you guys like it
Re: Finished, first knife project. (Update)
Posted: Fri Dec 15, 2017 12:09 am
by narach93
Looking nice.
Re: Finished, first knife project. (Update)
Posted: Sat Dec 16, 2017 11:34 am
by vjisaac
narach93 wrote:Looking nice.
Hi Narach93,
Thank you:)
Re: Finished, first knife project. (Update)
Posted: Sun Jan 21, 2018 1:41 pm
by rommel43
vjisaac wrote:Finally finished giving final touches, hope you guys like it
Looks good, man
How does the blade hold up?
Did you sharpen it to slice through paper or for heavier shopping and slicing? Because if it is sharp enough to slice paper, often it doesn't take stress very well.
Anyway it looks good. If you're using Pine wood, you can try burning the wood slightly to enhance the grain on it. And then use whatever finish you're using. Good luck, keep at it.
Re: Finished, first knife project. (Update)
Posted: Thu Feb 01, 2018 10:26 am
by vjisaac
rommel43 wrote:vjisaac wrote:Finally finished giving final touches, hope you guys like it
Looks good, man
How does the blade hold up?
Did you sharpen it to slice through paper or for heavier shopping and slicing? Because if it is sharp enough to slice paper, often it doesn't take stress very well.
Anyway it looks good. If you're using Pine wood, you can try burning the wood slightly to enhance the grain on it. And then use whatever finish you're using. Good luck, keep at it.
Hi romell43,
Thank you, yes it is sharpened to slice through paper. I will use pine wood next time and use your burning technique, thank you for the advise buddy
Regards
Re: Finished, first knife project. (Update)
Posted: Wed Feb 07, 2018 5:09 pm
by chetan4shooting
looking awesome...
which steel??
Re: Finished, first knife project. (Update)
Posted: Mon Feb 26, 2018 10:55 pm
by vjisaac
chetan4shooting wrote:looking awesome...
which steel??
Hi chetan4shooting,
The blade is made from a metal file