Indians For Guns

Hello,

Been practicing with my boker, and once the knife flew off and the tip bent.The plastic grips are quite slippery.How to make them grippy? I put insulation tape on my pull up bar and that worked very well.It was a slippery Galvanized iron pipe at first.Now, i regularly lose skin to it.

Perhaps this can be done to the grips? But that will look and feel uncouth i guess.Ideas?

Plastic grips?

Here you go





Use a drill or soldering iron or both

Pictures from survivalistboards.com

My grips are very thin, can't afford to weaken them.How bout a rubber sleeve or something extra on top?

Skyman wrote:My grips are very thin, can't afford to weaken them.How bout a rubber sleeve or something extra on top?

You have these rubber grips or tape "wrap around" non slip grips that are used on tennis and badminton rackets. What do you think?

Or take these off and get these sandblasted if that is possible for you.

First do a trial run on some similar material.

+1 the badminton grips idea.however they are too thick, mine is a frame lock.I guess tape is the way to go.NO cash available, 20 buck limit.

skyman...which model of boker?
stick a couple of strips of cycle inner tube onto the plastic scales. shouldn't cost you more than 5 bucks .

No model, it's a boker clone.Anything better than inner tube? How bout one of those silicone cases you get these days for phones?

a picture of the knife would help.

Dear Skyman
Its very simple just use Paracord which gives you very good grip.

Sowmi

Frame lock can't do that.

http://indiansforguns.com/download/file ... &mode=view

This one, correct?

I would try to fill the 3 grooves in the handle with something, Either gluing pieces of cord, or possibly twisted copper wire might not look too bad.

Visualize this:
and you cut pieces to fit the grooves, and glue it in with contact cement. With copper or brass wire it would even be attractive as opposed to some other methods (such as coating with glue and sprinkling it with sand) that will work well but to be honest are somewhat embarrassing to show off.

Another more time consuming approach would be to remove the rubber handles and make a set of your own out of wood, that would look the best of all.

Sorry! This was an oversight. I was under the impression that the subject knife was a fixed blade.

Now that I see that it is a folder, the size and the design I really do not see the reason why you would want it "grippier"

Hi Skyman, since the limit is 20 bucks, would suggest buying 150 Grit Emery Paper for INR 10 and sanding the scales. Or buy a small hacksaw blade and cut grroves along the scales. This should fix the problem.

The best solution would have been to stipple the scales using a Soldering Iron as shown by Rajat above, but then this would have to be purchased if you don't have access to it.

P.S: You mentioned practising with the knife, are you trained in martial arts.

Regards
Moin.