320 rifle with revolver chamber

[mundaire]

Unless I'm mistaken ckkalyan is talking about the hot burning gases that usually escape from the gap between the cylinder and the barrel.

[Sakobav]

Those gases can be dangerous some one did post a picture of pretty shredded thumb from gases of 357 cal Revolver ...

[ckkalyan]

Hi Abhijeet,

Unless I'm mistaken ckkalyan is talking about the hot burning gases that usually escape from the gap between the cylinder and the barrel.

The Smith and Wesson Model 320 revolving rifle was based heavily on the design of the Smith and Wesson Model 3 pistol.
977 revolving rifles were manufactured between 1879 and 1887. They were serial numbered 1 to 977, with 840 being sold in the U.S. while 137 were exported.

The revolving cylinder design, while popular with pistols, did not work well for rifles. The cylinder would spray out small fragments when the weapon was fired. This was not a problem for pistols, as both hands were behind the cylinder when firing. In the rifle version, though, the shooter's left hand was in front of the cylinder, resulting in the fragments being sprayed into the shooter's left forearm at high velocity. This undesirable characteristic significantly limited the revolving rifle's popularity.

The model 320 revolving rifle used a top break frame similar to that used on the model 3 pistol, and featured a detachable stock.

The revolving rifle used a special .32 caliber cartridge. The use of a cartridge was a significant improvement compared to the design of the Colt revolving rifle, which did not use cartridges and as a result was often subject to chain fire problems (the firing of all cylinders at once due to loose powder or residue in the weapon). While the Smith and Wesson Model 320 did not suffer from chain fire problems, the Model 320, like the Colt, tended to spray fragments from the cylinder into the shooter's forearm.

Source: http://en.wikipedia.org/wiki/Smith_and_ ... ving_Rifle