Indians For Guns

Got idea from Colt MAB , Mouser . Made these grips from piece of 100×65×10 MM wood then used Dremel drill rotor bits and then sandpaper 120,180,320 and finally 1000 grit filled pores with putty powder (better Use silly wood sealer I missed it )and finished with polyurethane commonly known as Touchwood with hand brush U can spray also I tried but got thick coating with spray then I removed it and used brush .
Comments and suggestions welcome

Sent from my LS-5015 using Tapatalk

Nice work, the finishing is really good like custom made. Cheers