Indians For Guns

Hello friends!
I am new to this forum and arms world. Just got my license few months back. For few days i am on practicing spree.

Yesterday, when i fired a round from my revolver one shell refused to came out. I thought to give some tome to it as i have seen in few blogs that it may come out after some time. But situation is same even now, after 12 hours.

What to do? Should i use screw driver to eject it forcefully or just head to a gunsmith, which is 70 decent km away from my place.

Waiting for advice.
Thanks.

Dear satish
My advice to you is to go to a gunsmith, as trying to eject the shell forcefully may damage ejector or some other part of your revolver,I did the same with my revolver once which result that chamber of revolver stops rotating ,so better to take precaution

Knocking a stuck case out of the cylinder is not going to hurt the revolver's ejector, nor any other part. Just be sure whatever rod you use to do it is in the case before you tap it, and the back of the cylinder is supported, so that any force is applied to the case only.

Hope this will give you some guidance.

Hope U have taken out shells ! In future don't lubricate cylinder too much better make it dry with cotton cloth before firing and just apply Molly grease at ejector rod. U can find moly ( Molebedenem ) grease at auto spare shop if u don't get it at gun shop

Sent from my LS-5015 using Tapatalk