Indians For Guns

hi,

i have spoken to nei hand tools and their alum single cavity mould will cost about AUSD 100 (including shipping) i will have to buy the handle seprately, they will cost AUSD 40 (including shipping)

then i will have to get my self a roll crimper, which will cost god knows what.

then get lead melt it make cast the slugs, open up unused shell and reload them using paradox slugs.

nope, no way am i gonna do this.

i'll simply shoot only bird shot in my gun.



rajat

Reloading is half the fun. What a waste....

hi,

this post is not actuallt relevent in this section, could the moderator kindly please move to the "shotgun section"

thanks

rajat

Lead from car wheel balancing weights is usually a good subsitute... 'least in my experience it has the required hardness etc... not sure of the exact lead/ alloy composition... but it works and IS AVAILABLE... if you want to use it, that is...

The legalities are another matter altogether

Moving this thread to the shotguns section (as suggested by Rajat)...

Cheers!
Abhijeet