Indians For Guns

Hi Friends,

I baught new Mandi made Shotgun Visco, 28 inch, 12bore sXs.
Today i fire 1st time but both shots fire same time. i used second tiger 1st fo firing.
is this problem with gun machanism. Because befoer this i used to fire single barral shot gun.


Regards
Kulraj Singh

A double barreled shotgun is not supposed to fire both the shots at the same time. Either you pressed both the triggers at same time or something is not correct with the shotgun.

I would suggest not to fire the gun again unless the problem is rectified because firing both the barrels at the same time doubles the recoil which the Indian made shotgun might not be able to withstand resulting in some kind of injury.
P.S. How much did you pay for the gun.

Kulraj: Did you have a finger on both triggers? The normal sequence is front trigger first (more open choke), then the rear trigger. Try it in that sequence, and if it still doubles, find a gunsmith who can fix it.

Probably something wrong with the mechanism....take it back to the dealer from whom u purchased it and he would rectify it..

Hi Vineet,

I bought this in 30k. from Ludhina.
Second this i bought just 3days before and today i fire 1st time just to check the firing macnasim...

Dear friends,
i press 2nd trigger 1st.

Is any one know any how i check the firing machanis of gun.


Regards
Kulraj Singh

KULRAJ wrote: i press 2nd trigger 1st.

Kulraj, a gun can be fired in any sequence i.e front trigger first and then the rear trigger or the rear trigger first and then the first trigger. There is no rule that says rear trigger can not be fired first.

If by firing one trigger both the barrels are going off then there is clearly a fault in the gun's mechanism. Talk to the dealer and try to get the piece changed or get it repaired by a good gunsmith.

KULRAJ wrote: Is any one know any how i check the firing machanis of gun.

Just dryfire the gun to check whether both the triggers gets decoked by pressing one trigger.If yes, then it definitely need a repair.

if you are not femiliar with a shot gun mechanism a gunsmith will do the job.
if you are adventurous open the mechanism and diy.
it should be easy if you have patience.
regards

I would recommend not to open the gun at home because if you do so then the dealer will get an excuse and will blame you for the fault. It has been just three days since you bought the gun and fired it for the first time. You should get it changed or atleast get it repaired free of cost by the dealer.

Hi Vineet

i talk with the Dealer "he told me bing the gun here he will show his gun smith".
This is my 1st indian gun which i bought. because all imported guns r almost atlest 30 year old i am i was affred to buy second hand gun....

Lets see what happen.

Hello Friends,

I check with Dealer he is going to send gun back to Mandi HP,
If any body know good gunsmith in Punjab tell me i will take this by my own.
and what is the approx cost comes

Regards
Kulraj Singh

There is a very good gunsmith in Faridkot who is specialist in shotguns. Earlier he has worked with IOF to manufacture shotguns. It is difficult to say what will be the cost. Only the gunsmith will be able to tell after seeing the gun. Rough estimate could be anything inbetween 1,000 to 2,000 rupees. I am sending his name and contact no. via PM.